SICK ICR890 Instrucciones de operaciones descargar pdf (Pagina 49)

Operating Instructions Chapter 4

ICR890

Installation

4.3 Installing and adjusting the device

The position of the components on the installation frame is specified project specifically in

a dimensional sheet (Fig. 4-1, page 46). The specifications have to be adhered to as far as

possible during installation, since the values influence the configuration of the system to

some extent.

Note A final (fine) adjustment of the components can only occur during startup (see Chapter 6.3,

page 80). Prerequisite for this is the complete electrical installation of the system (Chapter

5, page 53).

In order to facilitate component alignment, the deflection mirror and the unit consisting of

the illumination and the camera are attached to the installation frame via 180° brackets.

After loosening the clamping screws, the angle of the brackets can be adjusted from 0° to

180° as required. To achieve this, the clamping screws can be screwed into the various

threaded holes.

Abb. 4-6: Position of the components

Distance of the illumination and the

camera to the deflection mirror

Reference point

Reading location

15°

ICI890 Illumination

with ICD890

Camera

Deflection mirror

Direction of transport

Distance of the deflection mirror to the reference point

Abb. 4-7: 180° bracket for the deflection mirror and the illumination

Clamping screws

Bore holes for

fastening screws

Grooves for

guide pins

Bolts with slot nuts

for attachment to the

installation frame

Pivotal point

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 127 128

Sin comentarios

SICK ICR890 Instrucciones de operaciones Pagina 49