SICK CLV490 Instrucciones de operaciones descargar pdf (Pagina 113)

Operating Instructions Chapter 6

CLV490 Bar Code Scanner

Operation

(identical bar-code contents) received from all the slaves and sends this filtered overall

reading result for each object to the host at a defined output time during the reading

process. The object release point (data output) parameterized in the OTC400 marks the

end of the reading field. The object release point parameterized in the CLV490 must always

be smaller than that of the OTC400. The parameter setting for the focus release point

depends on whether the CLV490 is used as part of a group and on its position relative to

the conveyor belt. The focus release point is the point in the reading field at which the

CLV490 permits a new focus switchover when the tracked object has passed this point,

even if the number of bar codes to be read has not yet been reached.

Parameterizing slave mode in the CLV490:

OTC400 Controller:

Beside other functions parameterize the following function in the OTC400:

For further function to be parameterized in the OTC400 see the "OTS400 Omni Tracking

System" Operating instructions (order no. 8008869, English edition).

Action Settings in CLV-Setup

Parameterize CAN interface Ö CAN INTERFACE tab

Ö CAN INTERFACE FUNCTION section

– OTS slave

Ö CAN DATA RATE section

–500 kBit/s

Table 6-21: Guide: Parameterizing slave mode in the CLV490 for object tracking mode with OTC400

Action Settings in CLV-Setup

Pameterize operation mode in

the OTC400 (master)

Ö DEVICE CONFIGURATION tab

Ö READING TRIGGER PARAMETERS button

Ö OPERATING MODE section

– Increment controlled (Tracking)

Table 6-22: Guide: Parameterizing tracking mode in the OTC400

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 269 270

Sin comentarios

SICK CLV490 Instrucciones de operaciones Pagina 113