SICK ICR803 Manual de inicio rápido descargar pdf (Pagina 21)

- 21 -

Multiple Symbols

Note: This feature does not work when the Imager is in Low Power mode.

When this programming selection is turned On, it allows you to read multiple symbols with a single

pull of the Imager’s trigger. If you press and hold the trigger, aiming the Imager at a series of

symbols, it reads unique symbols once, beeping (if turned on) for each read. The imager attempts

to find and decode new symbols as long as the trigger is pulled. When this programming selection

is turned Off, the Imager will only read the symbol closest to the aiming beam.

No Read

With No Read turned On, the Imager notifies you if a code cannot be read. If using a Quick*View

Scan Data Window, an “NR” appears when a code cannot be read. If No Read is turned Off, the

“NR” will not appear.

The default no read message of ‘NR’ can be changed to ‘No Read’ by scanning the barcode below:

Output Default back

“No Read” to ‘NR’ message

If you want a different notation, for example, “Error,” or “Bad Code,” you can edit the output

message using the Data Formatter. The hex code for the No Read symbol is 9C.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 95 96

Sin comentarios

SICK ICR803 Manual de inicio rápido Pagina 21