
- 20 -
Output Sequence Editor
Require Output Sequence
When an output sequence is Required, all output data must conform to an edited sequence or the
imager will not transmit the output data to the host device. When it’s On/Not Required, the imager
will attempt to get the output data to conform to an edited sequence, but if it cannot, the imager
transmits all output data to the host device as is.
When the output sequence is Off, the bar code data is output to the host as the imager decodes it.
Note: This selection is unavailable when the Multiple Symbols Selection is turned on.
Comentarios a estos manuales