SICK ICR803 Manual de inicio rápido descargar pdf (Pagina 11)

ICR803 Bar Code Manual – Rev A – 04/2007 - 11 -

Manual Trigger, Low Power

The imager powers down until the trigger is pulled. When the trigger is pulled, the imager powers

up and operates until there is no triggering for the time set with the Low Power Time Out bar code

below. There is a delay of up to one second in operation when the imager is first triggered, but

there is no delay when operating in low power timeout mode.

Low Power Time Out Timer

Scan the Low Power Time Out bar code to change the time out duration (in seconds). Then scan

the time out duration (from 0-300 seconds) from Appendix D, and Save. Default = 120 seconds.

If the unit remains idle during the low power time out interval, the unit goes into low power mode.

Whenever the trigger is enabled, the low power time out timer is reset.

Note: This timeout does not begin until the imager timeout setting has expired.

Scan Stand Mode

When a unit is in Scan Stand mode, it remains idle as long as it sees the Scan Stand symbol. (See

Scan Stand Symbol that follows.) When a different code is presented, the Imager is triggered to

read the new code.

Note:The imager automatically adjusts the illumination LEDs to the lowest light level possible to

maintain a good lock on the Scan Stand symbol. When a symbol is presented, the imager’s light

levels adjust to the saved LED power setting.

Scan Stand Symbol

When a unit is in Scan Stand mode, the LEDs shine at the Scan Stand symbol on the base of the

stand which tells it to remain idle. When the Scan Stand symbol is covered, the imager turns the

LEDs on at the configured power level (Default High) and attempts to find and decode bar codes in

its field of view.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 95 96

Sin comentarios

SICK ICR803 Manual de inicio rápido Pagina 11